Quick Overview
(2pk $64 With Free S&H!)
Fits Some Whirlpool, Maytag, Amana, Jenn-Air, KitchenAid and Kenmore side-by-side refrigerators.
Located either (1.) Inside the Refrigerator or (2.) Thru The Lower Front Grille (Kickplate) with the Push Button Release.
Details
2pk $64 Free S&H | 3pk $93 Free S&H
Kenmore 9081 EveryDrop Whirlpool EDR1RXD1 FILTER1 W10295370A Refrigerator Water Filter AP5982535
Remember to replace your refrigerator filter every 6 months to maximize contaminant reduction.
Replaces Part Numbers: W10790813, AP5982535, PS11701542, AH11701542, EAP11701542, 9930, 46-9930, EDR1RXD1, W10295370A, W10295370, AP5672236, W10295370, P4RFWB, W10291030, P8RFKB2L, Kenmore 46-9930, 469930, 9930, 9930P, 04609930000, 46-9081, 469081, 9081, B00WIQEZC8, B014ML46TI, B00Z4EYHY2, B014MLC0WI.
Measurements Approx. 7 1/8 Inches Tall and 1 7/8 Inches Wide.
Certified to reduce the most contaminants — with Triple Filtration™ Technology
The Filter 1 reduces 24 contaminants
Does not remove fluoride from your water.
Installation Instructions
Interior Mount
- Locate filter compartment at the right upper corner inside the refrigerator.
- You might have to remove the upper shelf for more room.
- Gently lift up on filter cover and filter will automatically slide out.
- Slide old filter all the way out, noticing the arrow on the end is facing up. (the water will shut off automatically)
- Discard the old filter.
- Line the arrow on end of the new filter upward.
- Gently Push the new filter into the fridge with arrow facing up till it stops.
- As you close the filter cover you will notice that the filter will go in and lock into place.
- Reinstall Shelf (if taken out)
- Reset your change filter light (if your fridge has one)
Mounts Thru Lower Front Grill Mount
- Locate filter at the lower front grill of refrigerator.
- Gently lift up on filter cover and filter will automatically slide out.
- Slide old filter all the way out, noticing the arrow on the end is facing up. (the water will shut off automatically)
- Discard the old filter.
- Line the arrow on end of the new filter upward & Gently Push the new filter into the fridge with arrow facing up till it stops.
- As you close the filter cover you will notice that the filter will go in and lock into place.
- Reset your change filter light (if your fridge has one)
Resetting Your Filter Change Indicator
- Press the light switch (the one that the refrigerator door presses each time you close the door) 5 times within 10 seconds.
- OR: if the refrigerator has a filter button, press and hold it for 5-10 seconds.
Maintenance For Refrigerator Water Filtration System.
- Flush Filter with Water from Dispenser (Approximately 2 gallons) until Water Runs Clear and air is purged from system.
- Write the date of installation on the filter and mark your calander for 4 - 6 months as a reminder to Change Your Filter.